Broyhill 810398583 Assembly Instruction Manual Download Page 7

E-319

PAGE 6 OF 9

Read the following switch usage instructions for lighting and to extinguish:

CARE AND MAINTENANCE: 

1. Do not use aerosol polish or any other flammable 
    material to clean the burner while it is in use. 
2. Inspect and clean the burner regularly. Use a 
    wire-bristle brush to clean the burner surface. 
    A straightened paper clip is useful to remove debris 
    or rust from the small burner ports.
3. Wash frame parts with mild soap and water, rinse 
    thoroughly, and dry completely. Do not use bleach, 
    acid, or any other solvents on the frame parts. 
4. Inspect and tighten all of the bolts and fasteners on a 
    regular basis to ensure the proper performance and 
    safety of your appliance.
5. When not in use, we recommend that it be stored in a 
    dry and secure area. Always disconnect the propane 
    gas tank first and store it safely outside. 
6. The minimum clearance from the sides, rear, and top of 
    unit to adjacent combustible construction: 2' (61 cm) 
    from the sides, 2' (61 cm) from the rear, and 5' (152.5 cm) 
    from the top.
7. Improper lighting operations will cause serious injury 
    and explosion.

Switch Usage Instruction

Step 1: Lighting
Open the igniter button and install an AAA battery 
(not included), then secure the cap back on. Before 
use, make sure that the control knob is in the “OFF” 
position. Turn the propane cylinder gas valve to fully 
open position. Press down on the control knob and turn 
counter clockwise to the "LOW" position. Push in the 
gas control knob all the way and hold. Continue to 
press the ignition button for 15 seconds.

Step 2: Adjusting and Shutting Down
If the burner is not lit, press down the control knob 
and turn clockwise to the "OFF" position. Repeat step 
1 after 5 minutes. When the burner is lit, press down 
the control knob and turn it to the desired heat output 
position between “LOW” and “HIGH”. Press down 
and turn the control knob clockwise to the "OFF"
position to shut down the appliance. 
Turn off the cylinder gas valve.

Note: To extinguish the flame, push the control knob in and rotate clockwise.

CLOSE

AAA

OPEN

TYPES OF GAS                      PROPANE GAS

Caution:

 

The gas pressure regulator provided with this appliance 
must be used. This regulator is set for an outlet pressure of 
11 inches water column.

Min.Gas supply for input Adj.   25 psi

Maximum Inlet Pressure          250 psi

Manifold Pressure                   11 in.w.c

Gas Rating                               46,000 Btu/hr

OFF/Arrêt

LOW/
Min.

HI/
Max.

ON/ 

Allu-

          mage

OFF/ Arrêt

OFF/Arrêt

LOW/
Min.

HI/
Max.

ON/ 

Allu-

          mage

OFF/ Arrêt

SPECIFIC WARNINGS:

1) Both children and adults should be aware of the hazards of high surface temperatures and should 

    keep their distance in order to avoid burns and ignition of clothing.

2) Children should be under adult supervision when in the vicinity of this appliance.

3) Clothing or any other flammable materials should not be hung from or near this appliance.

4) Any guard or protective device removed for servicing the appliance must be replaced prior to use.

5) Installation and repair should be done by a qualified person. The appliance should be inspected 

    before use and at least annually by a qualified service technician. Frequent cleaning may be required. 

    It is imperative that the control compartment, burners, and circulating air passageways of the 

    appliance be kept clean at all times.         

WARNING:

Failure to position the parts in accordance with these diagrams or failure to use only parts specifically

approved with this appliance may result in property damage or personal injury.

Summary of Contents for 810398583











Reviews: