4
Setting up MC head amp
Only required set up on the MC board are
The load settings for your particular cartridge,
the Moving Coil head-amp is only required for
low output moving coil cartridges >2.5mV,
make sure that both switches at the back of the
unit, the input switch and board switch are in
the MC position
Pictured above are the red colored load switches
Found inside on the MC board, 4 different load
settings are included from top to bottom are:
1000,100, 50 and 20 ohms, if you need a custom
load, simply call or email with request
Pushing the switch to the right will engage the
load for that switch, ALWAYS power down
preamplifier before changing load setting.
