Brother ScanNCut DX Embossing Starter Kit, Operation Manual, Page: 9 / 10

9
p
Select "Emboss" on the preview screen, select the tool to
be used from the displayed screen, and touch the "OK"
key.
q Remove the holder cap, insert the 1.5 mm embossing tool
into the embossing tool holder so that

on the tool
aligns with

on the holder. After securing the holder
cap, insert the holder into the cartridge.
• If the 3 mm embossing tool is used, a softer embossing effect
can be created.
• Before inserting the holder into the cartridge, check if the tool
moves up and down in the holder. If the tool moves, remove
the cap, and then attach it again.
r
Touch , and then specify the embossing pressure.
• This table of values provides general guidelines.
• Some materials may tear if the embossing pressure is too strong
or the embossing speed is too fast.
• If necessary, adjust the setting for “Inward Offset”.
• If the desired embossing effect is not achieved, adjust the
embossing pressure. The embossing effect differs depending on
the type and thickness of the material.
s
Touch the "Start" key to start embossing.
t
Use the spatula to carefully peel the material from the
mat.
• Always remove the embossing tool holder from the carriage
after use and close the front tray of the machine.
Material Thickness
Embossing Pressure
1.5 mm tool 3 mm tool
Paper (thick) 0.25 mm 4 4