29
For Wireless Network Users
Wireless Network
Windows
®
M
acin
tosh
Manual configuration from the control panel (Windows
®
and Macintosh)
19
Configure the wireless
settings
a
On your machine, press
Menu
,
6
(
Network
),
2
(
WLAN
),
2
(
Setup Wizard
).
When
WLAN Enable ?
is displayed, press
1
to choose
On
. This will start the wireless setup
wizard.
Otherwise press
Stop/Exit
to exit from the
wireless setup wizard.
b
The machine will search for available SSIDs. If
a list of SSIDs is displayed, use the
a
or
b
key
to choose the SSID you wrote down in step
on page 24, then press
OK
.
If you are using an authentication and
encryption method that requires a Network
Key, go to
.
If your authentication method is Open System
and your encryption mode is None, go to
If your wireless access point/router supports
Wi-Fi Protected Setup,
Selected access
point supports WPS. Use WPS?
appears.
To connect your machine using the automatic
wireless mode, press
1
to choose
Yes
. (If you
choose
No
, go to
When
Start WPS on your wireless
access point/router,then choose
Next.
appears, press the Wi-Fi Protected
Setup button on your wireless access
point/router, and then press
1
.
c
Enter the Network Key you wrote down in
step
on page 24 using the dial pad to
choose each letter or number. To delete the
letters you have entered, press
Clear
.
For example, to enter the letter
a
, press the
2
key on the dial pad once. To enter the number
3
, press the
3
key on the dial pad seven times.
The letters appear in this order: lower case,
upper case and then numbers.
For more information, see
Press
OK
when you have entered all the
characters, then press
1
for
Yes
to apply your
settings. Go to
d
Your machine will now try to connect to your
wireless network using the information you
have entered.
e
A connection result message appears on the
LCD and a WLAN report will automatically be
printed.
If the connection failed, check the error code on
the printed report and refer to
To install the MFL-Pro Suite, continue to
.
For Windows
®
Users:
Now go to
For Macintosh Users:
Now go to
IMPORTANT
You must have the wireless settings you
wrote down for your network in step
page 24 before you proceed.
Note
• It will take several seconds to display a list of
available SSIDs.
• If a list of SSIDs is not displayed, make sure
your access point is on. Move your machine
closer to the access point and try starting from
again.
• If your access point is set to not broadcast the
SSID you will have to manually add the SSID
name. For details, see
Configuring your
machine when the SSID is not broadcast
in the
Network User's Guide
.
Wireless setup is now complete. A four
level indicator at the right of your
machine’s LCD will show the wireless
signal strength of your access
point/router.
