Brother Innov-is 1000, Operation Manual

Page: 173 / 181

172
APPENDIX
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
The start/stop button was pressed while the foot controller was
connected. You tried to use the foot controller for embroidery.
A stitch other than the buttonhole, bar tack or darning stitch was
selected and the start/stop button was pressed while the buttonhole
lever is lowered.
The buttonhole, bar tack or darning stitch was selected and the start/
stop button was pressed while the buttonhole lever is raised.
You tried to set a number of characters that will not fit within the frame.
The start/stop button or reverse/reinforcement stitch button was pressed
when no pattern is selected.
The twin needle setting is selected while a pattern that cannot be sewn
with the twin needle is selected.
The start/stop button was pressed without connecting the foot controller
while the setting for adjusting the stitch width using the sewing speed
controller is set to [ON]. You have selected a pattern for which width
control cannot be used.
You pressed the back key or the utility stitch key or the embroidery key
while a pattern was selected.
Bobbin thread has run out.
Little bobbin thread remains.
The reverse/reinforcement stitch button, needle position button or
thread cutter button was pressed while the bobbin winder shaft is
moved to the right.
A twin needle was set up with a pattern where a twin needle cannot be
selected.
A pattern is being stored.
The bobbin winder is winding the bobbin.
When the embroidery unit is attached.
Error Message Probable Cause