Brother HL-1260, Service Manual

Page: 390 / 483

CHAPTER 7 TROUBLESHOOTING
7–3
Error Messages
Error Message Meaning Action
31 PRINT OVERRUN
Print overrun Press the CONTINUE switch
to start printing the next page.
Data which overran the print
area on the page cannot be
printed. Check your page
protection setting with the
MODE switch. Setting page
protection to the correct size
could solve this problem. If
printing at 600 dpi, you may
need to add optional SIMM
memory. See page
5-7 .
32 BUFFER ERROR
Input buffer overflow Press the CONTINUE switch
to resume printing. Data lost in
overflow cannot be printed.
See page
4-46 .
34 MEMORY FULL
Work memory overflow Press the CONTINUE switch
to resume printing. If the same
error should occur after you
press the CONTINUE switch,
turn off the printer. Wait a few
seconds, then turn it on again.
Reduce the input buffer size.
See page
4-46 . Turn off
“KEEP PCL.” Add SIMM
memory with power off.
Download font and the fonts
saved in the HDD card might
cause the error, for it occupies
the same work area as the
RAM. Memory expansion is
recommended in that case. See
page
5-7 .
40 LINE ERROR
Error in the communications
circuit When the serial interface is
used, check the
communications parameters
such as baud rate, code type,
parity, and handshake
protocols. When the parallel
interface is used, check the
interface cable connection.
41 PRINT CHECK
Error in communication with
the engine controller Turn off the printer. Wait a few
seconds, then turn it on again.