Brother FAX-8650P, Service Manual

Page: 96 / 196

V
- 9
3.5 Firmware Switch Setting and Printout
[ A ] Firmware switch setting
n n
Function
The facsimile equipment incorporates the following firmware switch functions (WSW01 through
WSW41) which may be activated with the procedures using the control panel keys and buttons.
The firmware switches have been set at the factory in conformity to the communications standards
and codes of each country. Do not disturb them unless necessary. Some firmware switches may
not be applicable in some versions. The firmware switch data list indicates "Not used." for those
inapplicable switches.
Firmware Switches (WSW01 through WSW41)
WSW No. Function Reference Page
WSW01 Dial pulse setting
V -11
WSW02 Tone signal setting V -12
WSW03 PABX mode setting
V
-13
WSW04 TRANSFER facility setting V -15
WSW05 1st dial tone and busy tone detection
V
-16
WSW06
Pause key setting and 2nd dial tone detection V -18
WSW07 Dial tone setting 1
V
-20
WSW08 Dial tone setting 2
V -21
WSW09 Protocol definition 1
V
-22
WSW10 Protocol definition 2
V -23
WSW11 Busy tone setting V -24
WSW12 Signal detection condition setting
V
-25
WSW13 Modem setting
V -26
WSW14 AUTO ANS facility setting
V
-27
WSW15 REDIAL facility setting
V -28
WSW16 Function setting 1
V
-29
WSW17 Function setting 2
V -30
WSW18 Function setting 3
V
-31
WSW19 Transmission speed setting
V
-32
WSW20 Overseas communications mode setting V -33
WSW21 TAD setting 1
V
-34
WSW22 ECM setting
V -34
WSW23 Communications setting
V
-35
WSW24 TAD setting 2
V -36
WSW25 TAD setting 3
V
-37
WSW26 Function setting 4
V -38
WSW27 Function setting 5 V -39
WSW28 Function setting 6
V
-40
WSW29 Function setting 7 V -41
WSW30 Function setting 8
V
-41
WSW31 Function setting 9
V -42
WSW32 Function setting 10
V
-43
WSW33 Function setting 11
V -44
WSW34 Function setting 12
V
-45
WSW35 Function setting 13
V -45
WSW36 Function setting 14 V -46