sss
™
1143
page
15
10. Using a lint-free swab, apply conductive lubricant to the end of
the contact side drum bearings and install each bearing onto the
replacement drums (Figures 43a and 43b).
Figure 43a
Lint-Free Swab
Figure 43b
Drum
11. Install the drum onto the drum unit by sliding the drum drive side end
into the drum unit first (Figure 44).
Figure 44
Drum
Note:
Ensure the small, transparent, plastic, wiper tabs are
positioned on top of all the drums.
12. Rotate the drum contact bearing until the larger locking tab is
positioned at the top and set the contact side of the drum into the
drum unit Figures 45a, 45b and 45c.
Figure 45a
Drum
Figure 45b
Drum
Figure 45c
Large Locking Tab
i
nsTalling
The
D
rums
Note:
The following steps should be completed for each drum before the drum unit is assembled.
Contact Side
Drum Bearing
Contact Side
Drum Bearing
Drum Unit
Wiper Tab
i
nsTalling
The
D
rums
Small Locking Tab