3-104
Confidential
Maintenance unit
(2) Release the left end of the switching lever guide from the maintenance unit (viewed from
the rear) and remove the guide.
(3) If the ink absorber box has not been removed, pull out the main drain tube and air vent tube
from the ink absorber box.
Note:
Pinch the end of each tube with a clip in order to prevent drained ink from leaking
and the machine from getting stained with leaked ink.
Note:
If the main drain tube and air vent tube are disconnected from the ink absorber box,
they are reusable only one time by trimming their ends vertically 10 mm with scissors clear
and free of oil. Check that their cut surfaces are free of oil. If it is the second time for those
tubes to be disconnected, they need to be replaced.
(4) Remove the four screws (three "a" screws and one "b" screw) and detach the maintenance
unit from the engine unit.
"a": Taptite, cup B M3x10
"b": Taptite, cup S M3x6
Assembling Notes:
• Before setting the switching lever guide back into place, apply the specified lubricant to the
specified point, referring to
in this chapter.
• When mounting the switching lever guide on the maintenance unit, put it over the square
opening in the CR guide rail and then lightly push it down.
• When mounting the maintenance unit on the engine unit, fit the two bosses of the shaft holder
(on the left side of the maintenance unit) into the two holes under the CR guide rail.
Switching lever guide
"a"
"a"
"a"
CR frame
Carriage motor
harness
Maintenance unit
ASF motor/encoder harness ASSY
ASF encoder disc
ASF drive ASSY
ASF motor
(Rear)
CR guide rail
Holes
"b"
(3_098)
Summary of Contents for DCP-J925DW
