Brother DCP-7090, Service Manual

Page: 95 / 119

(6) (6) Remov Remove the T e the Taptite bi aptite bind B M3x10 screw nd B M3x10 screw. Release eac . Release each Hook, and remov h Hook, and remove the Regist e the Registration ration
front/rear actuator holder ASSY from the Registration chute. Pull out the Registration front/ front/rear actuator holder ASSY from the Registration chute. Pull out the Registration front/
rear sensor harness from the Hole.
rear sensor harness from the Hole.
Fig. 3-102 Fig. 3-102
Harness routing: Refer to Harness routing: Refer to “ “ 12 12 . . T T op side of op side of the registration chute the registration chute ” ” ..
Fig. 3-103 Fig. 3-103
Assembling Note: Assembling Note:
•• After asse After assembling the Regi mbling the Registratio stration front/rea n front/rear actuator hold r actuator holder ASSY to the Registratio er ASSY to the Registration n
chute, push the Actuators by fingers and check if they are pushed back by their springs chute, push the Actuators by fingers and check if they are pushed back by their springs
(if the springs are not caught at assembling).
(if the springs are not caught at assembling).
Registration front/rear actuator Registration front/rear actuator
holder ASSY
holder ASSY
Taptite bind B M3x10 Taptite bind B M3x10
Hooks Hooks
Hook Hook
Registration front/rear Registration front/rear
sensor harness
sensor harness
Hook Hook
Hole Hole
Registration chute Registration chute
<Bottom side> <Bottom side>
Registration chute Registration chute
Actuators Actuators
<Top side> <Top side>