4
2. Setup
Stand
Setting up the stand
a
Do not allow young children to play on or near the copyboard when it is set up
on its stand.
+
After removing the copyboard from its box, keep the printer and writing surface
covered in the bubble wrap packaging while setting up the copyboard.
1
Lay the copyboard on the floor
facing downward with the printer
control panel and writing surface
positioned over a piece of cloth or
other protective sheet to prevent
them from being damaged.
b
c
Do not exert pressure on the copyboard.
+
If the printer has been installed on the long edge of the copyboard, refer to
step
5
on page 12 for details on installing the printer on the short edge
before continuing this procedure.
If the stand is not attached, refer to page 15 for details on re-attaching it.
2
Grab the leg of the stand as shown in the illustration and slowly fold
out the stand.
a
Be careful not to pinch your finger between the plastic projection on
each leg of the stand and the stopper.
