12
Re-attach the main body to the engine unit
using the four fixings and slide the assembled
unit into the fireplace opening. Mark the two
wall fixing points and remove the fire from
the opening to enable drilling/wall fixing.
Re-position the fire and make any necessary
electrical connections.
Ensure the site is clear of debris before finally
securing the fire to the wall.
Please note wall plugs are not provided as
this will depend on the material the fire is to be
secured to.
Assembly – Desire, Ignite and Hereford Inset
Desire / Ignite 6 Inset Remote
Desire / Ignite 6 Inset Manual
Hereford 5 Inset Remote
Hereford 5 Inset Manual
Optional Hearth Fixing
In both cases (with our without back panel) the engine unit MUST be secure
before proceeding to attach the door. It is also possible to fix the engine unit to
the hearth should either of the above methods not provide an adequately secure
fixing in your individual installation.
With the main body attached to the engine
unit, slide the assembly into the opening (in
its final position).
Remove the main body by un-doing the
four fixings and carefully remove from the
engine, mark the two hearth fixing points
and remove the engine unit from the
opening.
Drill and plug the two fixing points (fixings
not supplied). Ensure the opening is
clear of debris and re-position the engine
unit (making any necessary electrical
connections in the process). Secure the
engine unit to the hearth.
Re-attach the main body using the four
fixings.