Brose E 41230, Original Operating Instructions

Page: 14 / 35

EN | 14 Assembly and adjustment // Brose Display Allround E41230
10 Mounting and adjusting the
control unit
› fig. C, page 3
1. Carefully remove the handle and open
the fastening of the brake, gear shift
and all other components mounted
on the selected side of the handlebar.
› Observe the respective manufac-
turer’s instructions for the compo-
nents and the e-bike.
2. Carefully loosen the grub screw (8)
with a size 2 mm (3/32 in.) hexagon
socket on the control unit.
› NOTE: The screw cannot be
removed from the control unit.
3. Slide the control unit onto the
handlebar from the side.
› Position the control unit close to the
handle so that all keys can be easily
operated by your thumb.
› Make sure that the connection cable
is not crushed or kinked.
4. Slightly tighten the grub screw with a
size 2 mm (3/32 in.) hexagon socket.
› Do not tighten the screw yet.
5. Check the position of the control unit.
› Are all buttons accessible with your
thumb?
› Is the display clearly visible?
6. Tighten the grub screw with the
hexagon socket.
› Torque: 0.3 Nm (max. 0.5 Nm).
7. Connect the plug (7) of the control
unit with the plug of the motor cable.
› This connection may vary depending
on the equipment of their e-bike.
11 Adjusting the control unit
› fig. C, page 3
1. Carefully loosen the grub screw (8)
with a size 2 mm (3/32 in.) hexagon
socket on the control unit.
› NOTE: The screw cannot be
removed from the control unit.
2. Adjust the position of the control unit.
› Are all buttons accessible with your
thumb?
› Is the display clearly visible?
3. Tighten the grub screw with the
hexagon socket.
› Torque: 0.3 Nm (max. 0.5 Nm).