4.
Switch on Battery isolation switch.
5.
Hold down seat switch, and
drive Carriage onto Rail using
a remote control.
Remember to remove the plastic end
pieces from the top of the rail.
6.
Remove yellow warning labels and transit screws attached to both upper and lower
carriage safety edges then fi t blanking plugs supplied into holes.
7.
Remove the Safe
Handling Aid.
SEE
PACKING INSTRUCTIONS.
17
1.2.5
Setting Seat Angle
The following procedure must be STRICTLY adhered to,
to avoid damage to the chassis plates.
1.
Remove the footrest hinge cover
by removing the screw.
2.
To remove main cover, remove the 2
screws that are located along the
front bottom edge.
3.
Gradually remove the cover on an angle.
It may be necessary to loosen the
footplate adjusting bolt.
Summary of Contents for Stairlift
