from the sensing chamber, making it insensitive. It is essential that all such ceiling
openings be closed with silicone sealant or similar.
1.
Run the two core cable to the Alarm locations.
2.
Bring the cable through the opening in the mounting plate (before screwing it to
the ceiling) see figure 9b.
3.
If you are bringing the wiring along the surface, break out the two notches (see
figure 10a).
4.
Using a small screwdriver, lift off the terminal block by raising it vertically (see
figure 10b).
5.
Screw the two cable cores into the terminal block (see figure 10b). Then carefully
press the terminal block back on to the two pins in the base.
6.
Twist the Alarm clockwise on to the mounting plate.
BREAK OUT
SIDE WALLS
USE SCREWDRIVER TO GENTLY
LIFT OUT THE TERMINAL BLOCK
SCREW
CABLES
INTO
TERMINAL
BLOCK
REAR OF
MOUNTING
PLATE
Figure 10a
Figure 10b
18
B17078-R0-Ei600 SERIE-BROOKS.indd 18
07/12/2010 11:11
