Unpacking and Inspection
High Capacity Helium Compressor
Shipping Carton Inspection
Manual
8040600
Brooks Automation
3-2
Revision A
Shipping Carton Inspection
Inspect the exterior of the shipping carton for visible signs of damage before
opening the shipping carton. Report any damage to the shipping company at
once.
Removal from Shipping Carton
Refer to
and use the following procedure to unpack the High
Capacity Helium Compressor.
1. Cut the straps on the exterior of the shipping pallet.
2. Lift the cardboard carton straight up and remove it from the pallet.
3. Cut the strap and remove the bolts that attach the ramp to the shipping
pallet.
4. Attach the ramp to the pallet and install the ramp pins in the pallet holes
5. Remove any excess shipping material from around the High Capacity
Helium Compressor.
6. Disengage the locks on the wheel assemblies.
Tipover Hazard
Injury to personnel may result if the High Capacity Helium
Compressor is allowed to roll freely down the ramp. Two
people are required to maintain control over the movement
of the High Capacity Helium Compressor.
7. Carefully roll the High Capacity Helium Compressor down the ramp
and onto the floor.
8. Carefully move the High Capacity Helium Compressor into its
installation position.
9. Refer to Section 3, Installation, for more information.
