brondell Swash T22-EW, Owner'S Manual

Page: 12 / 100

12
Please read these instructions carefully before
installing the Swash. Failure to do so could
result in flooding, leaking, or damage to the
product.
1. Existing toilet seat removal
a. Lift hinge covers and use a screwdriver
to remove the mounting bolts.
b. Remove the toilet seat; keep for future
use.
2. Turn off water supply valve and flush toilet
a. Turn water valve off to stop the flow of
water.
b. Flush toilet and hold down handle to
completely empty tank.
c. Disconnect water supply hose from toilet
tank; do not disconnect from the water
supply valve.
3. Connect the top of the T-valve to the
incoming water connection on the bottom
of your toilet tank
4. Connect the water supply line coming from
the wall to the bottom of the T-valve
PRODUCT INSTALLATION
Swash Installation
NOTE: Steps may vary by type of seat
and toilet
NOTES:
You may wish to place a container under
the tank to catch excess water.
Do not continue without completing the
above steps.
Failure to do so could result in flooding,
leaking, or damage to the Swash.
Steps 3,4
Step 2c
Continued following page
NOTES:
The T-valve connects to the fill valve
directly under your toilet tank—it does
not connect at the wall.
Check to ensure the rubber washer sits
flat inside of the T-valve.
Only connect to the cold toilet water
supply line.
If your water supply line is rigid you may
need to replace the water supply line
before continuing.