Bron Kobold EWB 200, Operating Instructions Manual

Page: 3 / 32

4
Attention! Important safety instructions -
Read carefully before starting up!
1.
The equipment should be used exclusively by qualified personnel.
2.
For safety reasons, the appliance may only be operated with an earthed mains
(AC-line) plug. When the appliance is switched on, the yellow LED display must
light up “earth ok”.
3.
Avoid incorrect use of any kind and be particularly careful not to obstruct the
natural circulation of air that keeps the lamp cool.
4.
The lamp and the accessory attachments may heat up to high temperatures.
Please handle with care.
5.
Use only intact connection cables. Position the cable so that it will not be tripped
over or make contact with hot surfaces. If an extension cable is necessary,
ensure that a cable is used with a current rating at least equal to that of the
ballast. Cables rated for less amperage than the appliance may overheat.
6. Units
with noticeable damage or which have been dropped must not be started
up. Contact a kobold service station. Service work or repairs must always be
carried out by a specialist.
7.
Only original spare parts must be used to guarantee long-term mechanical and
electrical operating safety. Incorrect reassembly can cause electric shock when
the ballast is subsequently used, even when the unit is closed.
8.
Before the ballast unit is cleaned or serviced or while it is not in use, it must be
switched off and completely disconnected from the mains supply. Never pull on
the cable itself: pull only on the plug housing.
9.
This drip-proof unit (IP 43) is designed for use indoors and outdoors, but when
subjected to drip water it must only be operated in the horizontal position. Do
not immerse, partly or completely, the ballast unit in water or other liquids. The
ballast unit should not be splashed with water or other liquids or exposed to a
continuous stream of water. A dangerous electric shock could be caused.
10. The use of an accessory attachment not recommended by the manufacturer
may cause a risk of fire, electric shock, or injury to persons.
11. The equipment must not be used in explosion-hazard areas.