4
5
www.bromicheating.com
www.bromicheating.com
IMPORTANT NOTES AND WARNINGS
WARNING
•
Read all instructions before installing or using this heater
•
Use this heater only as described in this manual. Any other use
not recommended by the manufacturer may cause fire, electric
shock, or injury to persons.
•
Improper installation, adjustment, or alteration and failure
to follow the warnings and instructions in this manual could
result in severe personal injury, death or property damage.
•
The manufacturer is not responsible for any damage that could
happen from improper use. The manufacturer emphasises that
this appliance should be used in a responsible manner and that
all procedures, warnings, and safety instructions contained in
this booklet be followed strictly.
•
This heater is not intended for use in bathrooms, laundry areas
and similar indoor locations. Never locate heater where it may
fall into a bathtub or other water container.
•
Do not install the heater directly near a bathtub, shower or
swimming pool. Any switches or controls must not be within
reach of a person in the bathtub, shower or swimming pool.
•
This heater is hot when in use. To avoid burns do not let bare
skin touch hot surfaces. Keep combustible materials such as
furniture, pillows, bedding, papers, clothes , etc. and curtains
at least 1 metre from the front the front of the heater and keep
them away from the sides and rear.
•
Extreme caution is necessary when any heater is used by
or near children or invalids and whenever the heater is left
operating and unattended.
•
This appliance is not intended for use by persons
(including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of
the appliance by a person responsible for their safety. Children
should be supervised to ensure that they do not play with the
appliance.
•
Keep packaging materials out of reach of children
•
Children and adults should be alerted to the hazards of high
surface temperatures and should stay away to avoid burns,
clothing ignition, or other serious personal injury
•
Children should be carefully supervised when they are in the
area of the heater.
•
Do not attempt to alter the unit in any manner.
•
Do not paint any surface of the heater.
•
Do not touch the heater with wet hands at any time.
•
Do not insert or allow foreign objects to enter front cover or
front opening as this may cause an electric shock or fire, or
damage the heater
•
Do not touch the heating surface at any time, even when the
heater is turned off and has cooled down.
•
Do not use or store flammable materials near this appliance
•
Do not spray aerosols or flammable materials in the vicinity
of this appliance while it is in operation
•
Never operate the heater in an explosive environment such as
areas where petrol or other flammable liquids or vapours are
stored.
•
Clothing or other flammable materials should not be hung
from the heater or placed on or near the heater.
INSTALLATION
•
IMPORTANT - Installation must be carried out by a licensed and
authorised person.
•
The installer is to ensure that the requirements of the local
authority, local electrical installation code, municipal building
codes, and any other relevant statutory regulations are carried
out.
•
After unpacking, make sure the appliance shows no signs
of visible damage or tampering. If the appliance appears
damaged, contact the place of purchase for assistance.
•
Remove transit protection before use.
•
This appliance must only be used on a 220-240 Volt AC Single
Phase electricity supply
•
This radiant heater is NOT intended to be installed on
recreational vehicles and/or boats.
•
Do not run cord under carpeting. Do not cover with throw rugs,
runners or the like arrange cord away from traffic area and
where it will not be tripped over
•
A heater has hot and arcing or sparking parts inside. Do not use
it in areas where gasoline, paint or flammable liquids are used
or stored.
•
To maintain Ingress Protection Rating (IPX4), only IPX4 rated
conduit fittings should be used for electrical installation.
•
Warning –To Reduce the risk of fire with Danger –To Avoid Fire
•
This warning tag shall be permanently affixed to the power
supply cord, no more than 152mm from the attachment plug
and the permanence of the warning tag shall be determined in
accordance with Test for Permanence of Cord Tag Section:53
•
This Installation, Operation and Service manual should not be
removed from the site of installation. Installer should leave
manual with the customer for future reference.
•
Any guard or other protective device removed for servicing
(conducted by an authorised person) must be replaced before
operating the heater.
•
Heaters are not intended to be installed in wardrobes.
•
The appliance must not be located directly below or in front of
a wall electricity socket. This is because the heat radiated from
the appliance may damage the electricity outlet or plug.
•
If the appliance has not been used, or will not be used, for a
long period of time, disconnect power supply
•
A means for all-pole disconnection of the heater must be
incorporated in the fixed wiring according to the local electrical
codes.
•
Do not mount the heater vertically. Install Heater so that
the infrared elements are horizontal. Failure to do this
may cause the heating element within the tube to sag and
cause premature burnout. Installing vertically will void the
manufacturer’s warranty.
CLEARANCE
•
Do not place articles on or against this appliance
•
A minimum safety distance of 1000mm should always be left in
front of the appliance.
•
This unit must be mounted at a minimum of 1800 mm above
the floor.
•
Be sure the heater is not facing the ceiling or flammable or
combustible substances/materials.
!
MAINTENANCE/ REPAIR
•
Installation and repair must be carried out by a qualified &
licenced service person only. The heater should be inspected
before use and at least annually serviced & inspected by a
qualified & licenced service person.
•
Do not perform maintenance until heater has been turned off,
power disconnected, and heater temperature has cooled to
room temperature.
•
Check for damage to the appliance regularly. If damage to
the appliance is suspected, discontinue use immediately and
contact the supplier or qualified person to repair.
•
At the end of this product’s useful life, it must not be disposed
of as domestic waste, but must be taken to a collection
centre for waste electrical and electronic equipment. It is the
user’s responsibility to dispose of this appliance through the
appropriate channels at the end of its useful life. Failure to do
so may incur the penalties established by laws governing waste
disposal. Proper differential collection, and the subsequent
recycling, processing and environmentally compatible
disposal of waste equipment avoids unnecessary damage to
the environment and possible related health risks, and also
promotes recycling of the materials used in the appliance. For
further information on waste collection and disposal, contact
your local waste disposal service, or the place of purchase
PRODUCT OVERVIEW
IMPORTANT NOTES AND WARNINGS
CONTINUES
...
PRODUCT FEATURES
•
The Tungsten Smart-Heat Electric heaters are
designed to provide efficient spot heating for
commercial and residential applications.
•
Suitable for indoor and outdoor heating
applications such as restaurants, cafes, bars and
clubs, factories, office spaces, designated smoking
areas, public areas, hotels and more.
•
The heaters are available in 2000W, 3000W,
4000W and 6000W models to suit a range of
environments.
•
High temperature corrosion-resistant coating.
•
IPX4 water ingress protection rating.
•
Soft glow infrared heating element - No harsh
glare.
•
Wall and ceiling mounting brackets allowing
adjustable angle of the heating direction.
•
Heater is equipped with spectral reflector for
excellent radiant heat output.
•
Patent Pending & Australian Registered Design
338721
SPECIFICATIONS
Model
2000W
3000W
4000W
6000W
No. of Elements
Single element
Single element
Double element
Double element
Bracket Length
164mm
164mm
244mm
244mm
Heat Output (Watts)
1.7 - 2.0kW
2.7 - 3.0kW
3.4 - 3.9kW
5.4 - 5.9kW
Heating Area*
up to 6m
2
up to 9m
2
up to 11m
2
up to 13m
2
Power connection required
(Volts/Amps)
220-240V - a.c.
- 50/60Hz/8.3 A
220-240V - a.c.
- 50/60Hz/12.5 A
220-240V - a.c.
- 50/60Hz/16.6 A
220-240V - a.c.
- 50/60Hz/25 A
Dimension (WxDxHmm)
1117 x 214 x 86mm 1410 x 214 x 86mm 1117 x 214 x 86mm 1410 x 214 x 86mm
Weight (kg)
9kg
10kg
9kg
10kg
Finish
Black High Temperature Coating
Approval
CE Approved
*Heating areas are based on protected environment with mounting height of 2400mm. For unprotected and extremely cold and windy environments
heating areas can be less. Please contact Bromic Heating for further advice.
