Bromic Heating DD0150CG, User Manual

Page: 6 / 12

•
The unit should not be used in threatening atmospheric or fire risk conditions.
•
Check that there are no defects on the unit resulting from its transportation. The manufacturer will not be liable for damage
suffered during transportation or arising from incorrect storage.
•
Check the operation of the moving components of the unit.
•
Check the safety of the control board, electrical cables and connections.
•
Check that all the interior and additional accessories are present.
•
GENERAL CONNECTIONS
•
Be sure the power cable is not damaged.
•
If the power cable is damaged it must be replaced by another type H05-VV-F or H05-VVH2-F. This repair must be
performed by qualified personnel.
•
It is essential that the electrical installation to which the unit is going to be connected has an EARTH LEAD, as well as the
necessary thermal and differential magnetic protection.
•
The power supply must have the suitable section for the consumption of the appliance.
•
If various units are installed in a row, each one must be connected independently to the power supply, avoiding the use of
extension leads or multiple plugs.
•
The manufacture disclaims all liability in the event that any of the above points are not followed.
•
OPERATING ELEMENTS AND INDICATORS
CAREL:
TURN ON/ OFF
Press until appear ON to turn on the unit.
To turn off the computer press the button for 5 sec until appear
OFF and the condensing unit will stop working.
Check set point
Press “set” 1 sec and the set point or set point will appear. Release key.
Up the set point
Press “up” .Release key.
Lower set point
Pulsar “a
•
One the inside of the unit is clean, connect the power supply
and place the switch in the
I/ON
position. The switch should
be lit up. The thermostat display shows the air temperature
inside the unit.
•
Three minutes after turning on the switch, the LED showing the
compressor is working will light up permanently.
•
The initial temperature that is shown on the thermostat display
will be the ambient temperature. As the machine works, the
temperature will reduce until it reaches its operating
temperature.
“down” . Release key.
COMPRESSOR THERMOSTAT
FAN
GÉNÉRAL SWITCH