B101784-4-0712
Page 7
7. Secure the Stabilizing Bracket to the Cart Assembly with
four 1/4-20 x 3/4 screws, four lock washers and four nuts. Do
not tighten. See Figure 5.
8. For alignment purposes, place two 1/4-20 x 3/4 screws into the
holes provided on the left side of the stabilizing bracket. See
Figure 5. These screws will be removed and reused in later
steps.
Figure 5
9. Secure Ignitor Heat Shield to the Stabilizing Bracket with
two 1/4-20 x 3/4 screws, two lock washers and two nuts. Push
snap-in grommet through the hole on the Ignitor Heat Shield.
See Figure 6.
Figure 6
10. Place Stiffener Brackets under the ledges of the Stabilizing
Bracket and Rear Panel. Ensure the holes line up and Secure
with four 1/4-20 x 3/4 screws, four lock washers and four nuts
each. See Figure 7.
FRONT
Figure 7
11. Use two 1/4-20 x 3/4 screws, two lock washers and two nuts
to further secure the Left and Right Panels to the Rear Panel.
See Figure 6.
Figure 8
12. Tighten all loose nuts and screws at this time.
Note: If necessary, align edges of cart panels and hold while
tightening.
13. Remove alignment screws placed in Step 8.
Note: This is REQUIRED.
C
Art
A
SSEmbly
