B102163-0-1113
Page 26
GRILL ASSEMBLY
Ignitor Wire
Note: Install the Ignitor Ground Wire before installing the burner.
1. Connect the ground wire to the ground lug on the collector box
before installing the burner into the grill.
See Figure 10.
Figure 10
Installing the Burner
1. The burner bracket should be at a slight angle as shown in
Figure 11. Once the proper angle is achieved, tighten the screw
securing the burner bracket to the venturi assembly and burner
body.
11°
“H” SERIES BURNER SHOWN
C
L
“H” Series Burner Shown
Figure 11
Burner Bracket Securing Bolt
1. Insert the 1/4-20 x 1 1/2 Phillips Truss Head Screw from the
underside of the grill and secure with the 1/4-20 Hex Nut.
See
Figure 8.
Figure 8
Note:
If the Grill Head is installed on a PCB1, PSCB or DCB1,
make sure the cart shield is not installed until the burner
bracket securing bolt is installed.
Install Head to Mounting
1. Install Grill Head on a Cart or Post Mounting (see Cart or Post
Installation Instructions that come with the mounting option).
Heat Shield / Wind Shield
Place the heat and wind shield in the grill bottom.
See Figure 9.
Figure 9
Note:
The heat shield cannot be installed until after the grill is
installed on a post or cart.
