B100400-5-0907
Page 2
Attention: You must wear gloves while grasping frame on smoker
shutter or handling smoker shutters.
If your Broilmaster is installed in the BIKH, grill surround, proceed
to Step 1.
If your Broilmaster is not installed in a BIKH, grill surround,
proceed to Step 4.
1. Remove front panel from grill surround
2. Place front panel face-up on a non-abrasive surface. When
facing the front panel, drill either a 7/8" diameter hole or
5/16" slot into upper, left corner of front panel. Refer to
Figure 1 for hole location or Figure 2 for slot location.
3. Insert bushing into 7/8 " diameter hole in front panel.
Figure 1
Figure 2
4. Remove retract-a-rack from grill body bottom.
5. If applicable, remove cooking grids from grill body
bottom.
6. If applicable, push lid stop into notch on grill body
bottom.
7. When facing grill body bottom, place hole template over left,
front edge of grill body bottom. The hole template must be
flush to the left side of grill body bottom.
8. Insert 1/8" drill bit into 1/8" hole in hole template. Drill 1/8"
pilot hole through grill body bottom. Remove hole template.
Enlarge 1/8" pilot hole with a 5/16" drill bit for final hole
size.
9. If applicable, replace front panel onto grill surround.
10. Remove knob from 7 1/2" actuator rod provided with
DPA100.
Attention: Use 7 1/2" actuator rod for standard smoker shutter
installation. Use 9" actuator rod when smoker shutter is
installed into a BIKH, Grill Surround.
11. Insert hook on either 7 1/2" or 9" actuator rod into 9/32"
hole in shutter linkage on left side of smoker shutter. The
hook is inserted from the outside to the inside on linkage bar
of smoker shutter. Refer to Figure 3.
Figure 3
