8 of 10
Flush Mount Rack Kit Installation Procedure
53-1002127-03
Attaching rear brackets to a rack
Complete the following steps to attach the rear brackets to the rack.
1. Position the right rear bracket in the right rear of the switch as shown in
2. Attach the brackets to the right rack upright using three 10-32 x 5/8-in. screws and retainer nuts.
3. Repeat
to attach the left rear bracket to the left rack upright.
4. Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lbs. (29 cm-kgs).
FIGURE 4
Attaching the rear brackets to a rack
2
Rear brackets, right (left side similar)
5
Screw, 10-32 x 5/8-in., panhead Phillips
6
Retainer nut, 10-32
2
5
6
