Brocade Communications Systems NetIron MLXe Series, Hardware Installation Manual

Page: 156 / 305

FIGURE 75 insertion and extraction tool
1. Hooked tab 2. Stepped tab
Use the tool to grasp the plug of the modular connector at its narrow end (the end closest to the attached cable), and insert the connector
into the proper interface module. Grasping the plug at the wide end during insertion may result in the tool being difficult to release and
remove.
When using the tool to extract the plug of a modular connector, cover the entire length of the plug with the tool. Notice that one end of
the tool has a "hook" side. Use this side to compress the locking tab while you remove the connector.
Brocade MLXe Series-32 cable management
The Brocade MLXe Series-32 cable management system allows access to the power supplies at the bottom of the router, and keeps the
air inlet clear in the center of the router (this is essential for proper cooling). Cable management hardware at the top, bottom and sides of
the router make it easier to route the cables in the proper directions.
In general, cables from the outer interface modules are routed horizontally and away from the router. Cables from the remaining modules
in the upper half of the router are routed up, then outwards along the channels.
Cables for modules in the lower half of the router follow a similar path downwards, above the power supplies. The following figure shows
the cable routing, with the upper and lower cable management system covers removed for clarity. The following sections describe cable
routing for each quadrant of the router.
Installing a Brocade MLXe Series-32 router
Brocade NetIron MLXe Series Hardware Installation Guide
156 53-1004203-04