IronWare Software Release 02.7.03a for Brocade BigIron RX Series Swtches
Release Notes v 1.0
Page 36 of 40
Defect ID:
DEFECT000284653
Technical Severity:
Medium
Summary:
Not able to set Extended IP ACL Protocol field to ESP(50) from SNMP
Symptom:
Customer was trying to implement ACL to RX from INM but failed.
Using CLI command the access list is added without any problem
access-list 105 permit esp host 1.1.1.1 host 2.2.2.2
Probability:
High
Feature:
SNMP Management
Function:
IP Mib
Reported In Release:
RX 02.7.02
Service Request ID:
241185
Defect ID:
DEFECT000286364
Technical Severity:
Medium
Summary:
Change gig auto negotiation behavior.
Symptom:
Currently, between two gig fiber interfaces, when one side is configured with gig-default auto
(default), the other side is gig-default neg-off, links show up at both sides. Default behavior will
change to the side with neg-off configured shows link up and the side with auto configured shows link
down. In addition: gig-default auto-full is added to switch back to the current behavior (none-default
behavior after the code change).
Probability:
Medium
Feature:
SYSTEM
Function:
OPTICS
Reported In Release:
RX 02.7.02
Service Request ID:
242203
Defect ID:
DEFECT000287890
Technical Severity:
Medium
Summary:
BGP "allowas-in" does not with confederation config
Symptom:
BGP Routes received from peer with local AS (in as-path) are dropped even though "allowas-in" is
used for that particular peer. We have observed this issue only when confederation is configured.
Without confederation it works fine.
Probability:
High
Feature:
BGP
Function:
BGPv4
Reported In Release:
RX 02.7.00
Defect ID:
DEFECT000288254
Technical Severity:
High
Summary:
Under "ipv6 router ospf", the "in" parameter after a "distribute-list prefix-list" isn't saved to the
running config.
Symptom:
Under "ipv6 router ospf", the "in" parameter after a "distribute-list prefix-list" isn't saved to the
running config even though it is required when entering a "distribute-list prefix-list". As a result, the
config is lost when the write mem command is issued and the device is reloaded.
Probability:
High
Feature:
OSPFv3
Function:
CONFIGURATION
Reported In Release:
RX 02.7.02
Service Request ID:
245558
Defect ID:
DEFECT000288573
Technical Severity:
Medium
Summary:
LAG port name was only displayed up to 9 characters.
Symptom:
LAG port names are being cutoff in the show lag output.
Probability:
Medium
Feature:
Character I/O
Function:
Character Handling
Reported In Release:
RX 02.7.02
Service Request ID:
244909
