6
5. CUT THE HOLE IN CUSTOM HOOD BASE
26¾”
13³/
8
”
HD0340A
If it is not done yet, cut a hole in the bottom of the custom hood, using the dimensions shown
at right.
NOTE: Keep in mind that the unit exterior flange is 3/4’’.
6. REMOVE FILTER
HD0366
Rest the power pack on a table. Remove tapes on filters. Lift filters from power pack by pushing
them towards the back and rotate, then set filters aside.
7. UNPLUG THE BLOWER(S)
HE0105
Unplug the blower(s) (one or two, depending on model) from the front panel.
8. REMOVE WIRING COVER AND FRONT PANEL
Using a Robertson or a Phillips no. 2 screwdriver, remove both wiring cover retaining screws
(
A
). Detach it from the power pack and set aside with its screws. Then, remove both sides
screws (
B
) retaining the front panel to the power pack. Carefully detach the front panel from
the power pack and set aside with its screws.
A
HD0365
B
