INST
ALLA
TION,
USE & CARE INSTR
UCTIONS
INST
ALLA
TION
7
A = 10¼” (all units)
B = 19
9
/
16
” (PM400SS)
B = 22 ¹/
16
” (BBN2243SS)
B = 28 ¹/
16
” (BBN2303SS)
PREPARE THE CABINET
WARNING
The cabinet must be secured to wall studs or other
wooden framework behind the drywall to support
the weight of this unit . Failure to do so may cause
personal injury or damage to countertop or cooktop .
NOTES: A . The unit has to be installed inside the cabinet . If
installing with one of the optional liners (
PM400SS
unit only
), use it as a template to cut the hole in
the bottom of the cabinet .
B . The unit should be mounted centered laterally
over the cooktop burners .
C . For back to front position, the unit must be
mounted according to local building codes .
1 . Cut a hole in the bottom of the cabinet, using the
dimensions shown (FIG . 6), or use the optional liner as a
template (
PM400SS unit only
) .
2 .
PM400SS unit only
: Where needed, install the metal liner .
3 . Measure the remaining material of the cabinet bottom sides
(
C
), (FIG . 7) if it is 1/4” or more, there is no need to use
the cabinet brackets . Go to step 8 on page 9 .
4 . When there is less than 1/4” remaining material (
C
),
carefully remove those strips . Measure the cabinet inner
width (
D
) (FIG . 7) . Refer to the table below to see which
cabinet bracket edge configuration must be used .
5 . Locate the Ease of Install Hooks (circled in FIG . 8) on the
unit . Temporary insert the unit in the cabinet, while holding
the unit, mark the position of the Ease of Install Hooks
(shown as
E
in FIG . 9 on next page) on both cabinet side
walls . Remove the unit .
U
nit
n
arrow
edge
w
ide
edge
PM400SS
D
From 19-9/16”
to < 20”
D
From 20”
to 20-1/2”
BBN2243SS
D
From 22-1/16”
to < 22-1/2”
D
From 22-1/2”
to 23”
BBN2303SS
D
From 28-1/16”
to < 28-1/2”
D
From 28-1/2”
to 29”
!
HD1381
CUT A HOLE IN THE BOTTOM OF THE CABINET
FIG. 6
HD1382
FIG. 7
HD1387
FIG. 8
FRONT
UNIT TOP VIEW
