SA-S500 Series
4
Security Analytics
Quick Start Guide
Read the “Rack Mount Warnings” section of the
Safety
and Compliance Guide
.
Take adequate safety and grounding measures to avoid
creating an electrical shock hazard and to prevent
bodily injury.
The appliance is heavy. A two-person lift or mechanical
aid is recommended to lift the appliance from the carton
and install it in the rack.
Do not place objects on the appliance or use it as a
work surface. Its mounting hardware does not support
additional weight.
Attach the Chassis Rails to the Appliance
The slide-rail assemblies come pre-assembled with the
inner chassis rails inside the slide rails. The chassis rails
attach to the appliance chassis. The slide rails are installed
in the equipment rack.
To attach the chassis rails to the appliance:
1. Disassemble the two slide-rail assemblies:
Fully extend each slide rail by sliding out the chassis
rails until they reach the stop.
Press the release tab on the chassis rails and slide
them all the way out.
The chassis rails are symmetrical and can be attached
to either side of the chassis.
2. Attach the two chassis rails to the appliance:
Align each rail to the mounting posts on each side of the
chassis.
Slide the rail toward the rear of the chassis until the
mounting posts snap into place.
Secure each inner rail to the appliance with one M4x4L
screw.
3. Test the slide-rail release latches. They should move
smoothly in both directions with minimal effort.
4. Set the appliance aside in a safe location.
Install the Slide Rails in a 4-Post Rack
For installation in 4-post equipment racks, the slide rails use
the Bracket_A and Bracket_C assemblies.
To install the slide rails in a 4-post equipment rack:
1. Assemble the two slide rails:
Loosely attach Bracket_C to the Bracket_A assembly.
Secure the brackets with three M4x5L screws, inserted
through the slot in Bracket_C and screwed into three
holes in Bracket_A.
Make sure the screws are equidistant from each other
so the load will be evenly distributed on the rail. Do not
yet fully tighten the screws.
The precise attachment location of the side-mounting
screws will depend on how far Bracket_C will extend or
retract to fit the rack. It may be necessary to remove
Bracket_C from Bracket_A to determine the proper
installation length.
2. Install the assembled slide rails in the 4-post rack:
Secure Bracket_A to the outside front of the rack with
two M6 rack screws. Do not yet fully tighten the screws.
You will do so after the appliance is installed in the rack.
Extend or retract Bracket_C to align with the outside
rear of the rack. Secure the bracket with two M6 rack
screws. Do not yet fully tighten the screws. You will do
so after the appliance is installed in the rack.
Tighten the three side-mounting M4x5L screws,
securing Bracket_C to Bracket_A, for each slide rail.
Bracket_C
Bracket_A
