e-mail:
voice:
360.854.9559
fax:
866.783.1742
20
Streaming Sentinel 4 Installation and Operation Manual
WEB SETUP
“Email/Network Setup” Web Page – NTP Settings
NTP Enabled:
Enable for NTP network time sync.
Default: Enabled
NTP (Time) Server Address: Enter the NTP address here.
Default: pool.ntp.org
NTP Port:
Port used to connect to NTP server. Default: 123
NTP Update Interval (Min): Interval between time updates.
Default: 60
“Email/Network Setup” Web Page – Other Settings
Site ID:
This is the Site Identifier that is displayed on the web
and in email.
Monitor Refresh Time (Sec): Interval at which the Monitor page refreshes. Shorter
times may increase network traffic.
Time Zone Offset from UTC: Sets the time zone used for the internal clock.
Default: -8
Enable Daylight Savings:
Adjusts the clock for daylight savings time.
Set Time:
The hour, minute, second, month, day and year boxes
can be used to set the time of the real time clock. The
time is only updated if you click “Save Time” and not
when you “Save Settings”.
Enable Event Logging:
Event logging will generate an alarm, but it will not
send an email. If the system is configured for Daily
Alarm emails, then that Daily Alarm email will con-
tain the event logging alarms as well as the alarms
configured on the I/O Setup page.
Login:
When someone logs into the unit, the username and
date/time will be logged.
Email:
When an email is sent, the type of email and date/time
will be logged.
Reboot:
When the device boots the date/time will be logged.
Alarms Cleared:
When the Daily Logs or Normal Alarms are cleared,
the type of log cleared and date/time will be stored.
When Daily Logs are sent, the Daily Logs are also
cleared; this will cause an event log as well.
NOTE:
A cold-start trap will
be sent when the unit
boots up if the SNMP
Enable Traps are
enabled and trap mes-
sages will be sent when
a device enters or exits
an alarm condition,
depending on whether
or not alarms are
enabled.
WEBSITE:
Visit our web site for
product updates and
additional information.
