e-mail:
voice:
360.854.9559
fax:
866.783.1742
17
Status Sentinel 16 Installation and Operation Manual
SET UP
“Email/Network Setup” Web Page – “Optional” Relay Sentinel® 16 Settings
Relay Sentinel® 16 IP Address: Enter the IP address of the Relay Sentinel® 16
being used.
Relay Sentinel® 16 port: Enter the port of the Relay Sentinel® 16. Normally 10001
NOTE: Normally left blank unless paired with the Relay Sentinel® 16 to form a
“16 Channel Relay Extension Cord”. The above two entries will need the Relay
Sentinel® 16’s IP address and port number entered in the above locations.
“Email/Network Setup” Web Page – NTP Settings
NTP (Time) Server Address:
Enter the NTP address here.
Default: pool.ntp.org
NTP Port:
Normally 123.
Default: 123
NTP Update Interval (Min):
Time between timing updates. Default: 30
NTP Enabled:
Must be enabled for correct timing.
Default: Enabled
“Email/Network Setup” Web Page – Other Settings
Site ID:
This is the Site Identifier that will be sent in each email.
Monitor Refresh Time (Sec):
How many seconds the Monitor page refreshes. Shorter
times may increase network traffic.
Time Zone Offset from UTC:
Must be set for correct timing.
Default: -8
Enable Event Logging:
Enabling these checkboxes will generate an alarm, but will
not send an email. If the system is configured for Daily
Alarm emails, then that Daily Alarm email will contain the
Event Logging items as well.
Login:
Whenever someone logs into the system, the username and
date/time will be logged.
Email:
Whenever an email is sent, the type of email and date/time
will be logged.
Reboot:
Whenever the device boots, the date/time will be logged.
Alarms Cleared:
Whenever the Daily Logs or Normal Alarms are cleared,
the type of log cleared and date/time will be stored. When
Daily Logs are sent, the Daily Logs are also cleared; this
will cause an event log as well.
WEBSITE:
Visit our web site for
product updates and
additional information.
