e-mail:
voice:
360.854.9559
fax:
866.783.1742
8
SS 2.1 MLR/RJ Installation and Operation Manual
CONFIGURATION
WEBSITE:
Visit our web site for
product updates and
additional information.
Configuration
Configuration Jumpers
JP3:
N.O. = Configures relay K5 (SS/Silence Sense) to Normally Open.
(Factory Default)
N.C. = Configures relay K5 (SS/Silence Sense) to Normally Closed.
JP4:
Disabled = Front panel enable switch defeated. (Factory Default)
Enabled = Front panel ENABLE push button active. The enable LED is
illuminated.
NOTE: With JP4 enabled the enable push button must be held on/closed to
operate any of the other front panel push buttons, this does not affect the
remote-control functions.
Configuration DIP-switch Setup (SW5)
Follow the tables below for configuration options.
Unit ID
SW5-1
SW5-2
ID 0 *
OFF
OFF
ID 1
ON
OFF
ID 2
OFF
ON
ID 3
ON
ON
Baud Rate SW5-3
SW5-4
2400
ON
OFF
9600*
OFF
OFF
19200
OFF
ON
38400
ON
ON
Power Up
SW5-5
User selected
ON
Last source selected*
OFF
Note: *To select an input at power-up with SW5-5 ON, hold down the push-
button for the desired input channel or mute until the front panel LED’s flash.
Remote Control Operation Modes
SW5-6
SW5-7
Normal *
OFF
OFF
Sustained
ON
OFF
EAS/MSRP
OFF
ON
Toggle
ON
ON
• Normal operation mode: Pulse 1-IN to select channel 1, Pulse IN-2 to select
channel 2, or pulse the “M-IN” (mute) pin to turn off both channels.
• Sustained operation mode: Hold IN-2 low to select channel 2. Release In-2 to
switch back to channel 1.
• EAS/MSRP operation mode: See Sage ENDEC EAS Installation Guidelines sec-
tion of this manual.
• Toggle operation mode: Alternately pulse 1-IN to select between the two channels.
Note: After changing any dipswitch, please repower the unit.
Note: * Denotes factory setting.
