e-mail:
voice:
360.854.9559
fax:
866.783.1742
8
Mixer Buddy II Installation and Operation Manual
OPERATION
OPERATION
Plug the supplied external PS-1515 +/-15 VDC power supply in to the POWER jack
on the rear of the Mixer Buddy II.
Microphone On/Off Control
The microphones are turned ON or OFF via the front panel pushbutton switches
labelled 1-4. The LED below each button will illuminate indicating that the select-
ed microphone channel is switched ON. The monitor speaker output will mute
whenever any of the microphones are switched ON via the Mixer Buddy II. The
“Mic Tally” on air light relay output will be active whenever any of the microphones
are switched ON via the Mixer Buddy II
Monitor Speaker Source Selection and Volume Control
The “Monitor Select” pushbutton switch allows you to switch between the two mon-
itor audio input sources, selecting one or the other to be fed to the monitor output
labelled “Speaker Amplifier/Power Speakers.” The two LEDs labelled “EXT” and
“PGM” respectively indicate which source is selected, either the External Input or
the Mixer Program Input.
The Monitor Speaker Level control knob labelled “MON LVL” may be used to
adjust the monitor volume level.
Note: The monitors and microphone on/off functions will still operate even if the
Mixer Buddy II is powered down. Power is required to activate the monitor mute
operate the on-air light relay, drive the output to hybrid, as well as illuminate
the front panel LED’s.
WEBSITE:
Visit our web site for
product updates and
additional information.
