LBO-DVI-EAD User’s Manual
Link Bridge
TM
Fiber Optic DVI Wall Plate and Standalone Transmitter System
Broadata Technical Support, (800) 214-0222
8
2.0 SETUP
LBO-DVI-EAD-T is a transmitter that can be paired with any DVI/HDMI
centric LBO receiver (such as LBO-DVI-R). One LBO-DVI-EAD-T
transmitter unit is located at the near-end and connected through one
optical fiber, to the LBO-DVI-EAD-R receiver located at the far-end of
the link. Figure 2-1 depicts a typical installation for the LBO-DVI-EAD-T.
Figure 2-1
LBO-DVI-EAD-T with LBO-DVI-EAD-R
2.1 Mounting
Before installing the units into your housing, make sure there is
enough space to pull and connect both the electrical and optical
cables without stressing them beyond the manufacturer’s
limitations (also known as the minimum bend radius).
2.2 Cabling and Connectors
In order to setup the LBO-DVI-EAD-T properly, make sure to
observe the following instructions when installing the proper
cables. The LBO-DVI-EAD-T requires two parts to the cabling
setup, the electrical and the optical.
