LD-POWER240
BRITEQ
4A
4. Installing instructions
The LD-POWER240 should be placed on a non-flammable flat surface in any
orientation and fixed by screws. There are mounting holes on the housing. Ensure
that installation place is enough ventilated.
The LD-POWER240 power output is 240 watt (4
×
60W ).
LD-POWER240
BRITEQ
5A
5. Main Function
To select any function, press
MENU
button until the required one is shown on
the display. Select the function by
ENTER
button and the display will blink. Use
DOWN
and
UP
button to change the mode. Once the required mode has been
selected, press
ENTER
button to setup. Back to the functions without any change
press
MENU
button.
Press
MENU
button for 3 seconds to exit the functions, press “Chase Group 1”,
“Chase Group 2” or “Chase Group 3” button to run the built-in chase or you have
programmed. Enter chase group, the LED on, then press the chase group button
again to choose the chase. Once the chase has been selected, press “Manual”
button into manual mode, the LED on, you can choose the step one by one; press
“Fade” button into fade mode, the LED on, the unit will run all steps of the chase
automatically, at this time, you can press
UP/DOWN
button to adjust the fade time;
press the “Auto” button into auto mode, the LED on, the unit will also run all steps
automatically, and you can press
UP/DOWN
button to adjust the wait time; press the
“Blackout” button, the LED on and the unit into blackout mode.
