ENGLISH
OPERATION MANUAL
BRITEQ
®
2/3
BT-THEATRE YOKE
DESCRIPTION:
1. TV-SPIGOT:
rotating 28mm TV-spigot to easily hang the bracket. See (2) for more information. A
combination of an optional
“TV-SPIGOT RECEIVER” and FASTCLAMP is needed to fix the bracket in the
truss.
2. WHITE POLE KNOB:
While operating this knob the TV-spigot (1) rotates in order to pan the projector and
point it in the desired horizontal direction.
3. BLUE POLE KNOB:
While operating this knob the complete projector tilts the projector and points it in the
desired vertical direction.
4. FIXING CYLINDER:
these 2 parts are fixed on both sides of the BT-THEATRE 150EZ/250EZ and are
needed to adapt the pole yoke to the projector.
5. M8 HEX BOLT L=20mm:
together with the washer this short HEX bolt is used to fix the pole yoke to the
projector on the side with display / controls.
6. BIG COPPER WASHER:
used to make sure that the tilt movement is smooth.
7. M8 HEX BOLT L=65mm:
together with the washer this long HEX bolt is used to fix the pole yoke to the
projector on the side without display / controls.
MECHANICAL ASSEMBLY:
1.
Unscrew the 2 handles of the original bracket and remove the complete bracket.
2.
Loosen the 8 screws of the original (thinner) fixing cylinders and remove the cylinders on both sides.
3.
Use the 8 included longer screws to install the new (thicker) fixing cylinders on the projector.
4.
Put the new BT-THEATRE POLE YOKE in place (white pole knob on the back of the projector) and use
the included M8 HEX bolts + washers as
shown on the picture in the previous chapter
.
Attention:
don
’t forget the big copper washer (6) !
