ENGLISH
OPERATION MANUAL
BRITEQ
®
4/6
BT-PROFILE250 LED ENGINE
12. SECURITY KNOBS FOR OPTICS:
2 knobs to prevent that the OPTICS can come loose from the LED
ENGINE. To change the optics you should loosen both knobs, see further instructions in the next
chapter. To simply turn the optics over a certain angle, you only have to loosen both knobs a little.
INSTALLING THE OPTICS
For maximum flexibility the LED ENGINE and OPTICS are sold separately. Also you can install optics from
some other brands which even increases flexibility for professional rental companies. In this chapter we
describe how the install the install/exchange the optics on the LED ENGINE.
A.
Loosen the 2 security knobs (12) so it will be possible to fix the optics on the led engine.
B.
On the LED ENGINE you will notice 4 bulges (A)
C.
On the OPTICS you will see 4 notches (B)
D.
Take the OPTICS and turn is over about 45° so the 4 bulges (A) and 4 notches (B) are facing each other
and the two parts fit into each other.
E.
Now rotate the OPTICS over about 45°: both parts are now joined together.
F.
Fasten the 2 security knobs (12) to assure that both parts stay together, also while turning the optics.
Remark: in the beginning it needs some practice to install and remove the optics on the LED Engine, after a
while it will be a piece of cake for you!
OPERATING INSTRUCTIONS / SETUP MENU
The light output of the projector can be controlled manually or via DMX. Below we explain you the different
functions of the setup menu:
DMX Address (DMX Addr)
Set the DMX address and use the projector in DMX-mode.
•
Press the MENU-button (2) until the disp
lay shows “DMX Addr”
•
Press the UP/DOWN buttons (3) to set the desired DMX address.
•
Press the ENTER button (4) to confirm.
The display shows the DMX-address while the projector is now in
working in DMX-mode.
Remark: If no DMX-signal is detected, the backlight will flash to
indicate that there is a problem.
Manual Dimming (Manu Dim)
Setting the dimmer manually using the UP/DOWN buttons (3&4)
•
Press the MENU-button (2) until the display shows [Manu Dim]
•
Press the UP/DOWN buttons (3&4) to set the desired DMX address.
•
Press the ENTER button (5) to confirm.
Important:
if you don’t confirm the dimmer value by pressing ENTER, the dimmer will (after 5secs)
automatically return to the last setting.
DMX Mode
Used to select if the dimmer should work in 8bit or 16bit mode while controlled via DMX.
•
Press the MENU-button (2) until the display shows [DMX Mode]
