ENGLISH
USER MANUAL
BRITEQ
®
8/9
BT-NONAMOVE
DMX-CONFIGURATION:
5CH
18CH 34CH 50CH VALUES
FUNCTION
Remarks
1
1
1
1
000-255
PAN (0-100%)
2
2
2
2
000-255
PAN FINE (0-100%)
3
3
3
3
000-255
TILT (0-100%)
4
4
4
4
000-255
TILT FINE(0-100%)
5
5
5
5
000-220
PAN/TILT SPEED FAST TO SLOW
221-248
NOT USED
249
PAN/TILT RESET
250-255
NOT USED
6
6
6
First channel of the BT-NONABEAM (follows automatically)
…
...
…
…
18
34
50
Last channel of the BT-NONABEAM channels
Remark:
the full DMX-configuration, including BT-NONABEAM, can be downloaded from our website.
RDM FUNCTIONS / REMOTE SETUP
RDM
means “
R
emote
D
evice
M
anagement”. This projector works with a brief set of RDM
-functions which
means that it can setup a bi-directional communication with an RDM-compatible DMX-controller. Some of
these functions are briefly explained below, others will be added in the future.
•
The DMX-
controller sends out a “discovery command”, all RDM devices respond and send their unique
device ID.
•
The DMX-controller asks each RDM device for some basic data so it knows which devices are connected.
The projector will respond:
•
Device name:
BT-NONAMOVE
•
Manufacturer:
Briteq
®
•
Category:
fixture moving yoke
•
Firmware:
x.x.x.x
(firmware version of the projector)
•
DMX address:
xxx
(current DMX start address of the projector)
•
DMX footprint:
xx
(number of DMX-channels used by the projector)
•
Personality:
xx
(current personality or DMX-working mode used by the projectors)
•
…
•
The DMX-controller can send certain commands to each RDM device which allow remote setup of the
units. Thanks to this the projector can be setup remotely.
The following functions can be managed remotely:
No more need to take a ladder and set all units one by one!
•
DMX START ADDRESS:
The start address can be set remotely from 001 to xxx.
•
PERSONALITY:
The DMX working mode (DMX-chart) can be set remotely.
These 2 functions make it possible to prepare a complete DMX-patch of all projectors on the DMX-controller
and send these data to all projectors at once. More functions will be added later.
MAINTENANCE
•
Make sure the area below the installation place is free from unwanted persons during servicing.
•
Switch off the unit, unplug the mains cable and wait until the unit is cooled down.
During inspection the following points should be checked:
•
All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
•
Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
•
When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
•
The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
•
In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be
