ENGLISH
USER MANUAL
Briteq
®
5/13
BT-AKKULITE IP
WIRELESS SOLUTION
•
Switch all projectors on.
•
Put all projectors in the desired DMX-channel mode (see chapter [SETUP MENU]: option [
CHnd]
)
•
Set the desired DMX start address on all projectors, take in account the number of DMX channels used
by the selected DMX-channel mode! (see chapter [SETUP MENU]: option [
Addr]
)
•
Switch on the wireless mode using button (2).
•
Synchronize all projectors with the wireless DMX transmitter. (for example : Briteq
®
“WT-DMXG4”
transmitter is 100% compatible) (see chapter [SETUP FOR WIRELESS OPERATION])
•
Once this is done everything should work.
MIXED SOLUTION
•
Daisy chain all projectors using good quality balanced microphone/DMX cables.
•
Switch all projectors on.
•
Put all projectors in the desired DMX-channel mode (see chapter [SETUP MENU]: option [
ChMd]
)
•
Set the desired DMX start address on all projectors, take in account the number of DMX channels used
by the selected DMX-channel mode! (see chapter [SETUP MENU]: option [
Addr]
)
•
Synchronize the first projector in the DMX-chain with the wireless DMX transmitter (for example : Briteq
®
“WT-DMXG4” transmitter is 100% compatible): (see chapter [SETUP MENU])
•
Once this is done, the first unit is controlled by wireless DMX and will pass the DMX-signal to the other
projectors via the wired DMX-chain.
WIRED SOLUTION
•
Same as the MIXED solution but the first unit in the chain also receives the DMX-signal from a DMX-
cable plugged in its DMX-input connector.
Note: when a wireless DMX-signal is detected
, this “wireless” DMX-signal will take precedence over the
wired DMX-signal.