04
05
7. TO ADJUST THE LEG SUPPORT
A
Lower the leg support by pressing up the release
latches located underneath on both sides of the leg
support. Then push the leg support down.
B
Raise the leg support by lifting it until the release
latches lock into place.
8. TO ADJUST THE BACKREST
A
Squeeze both the right hand and left hand latches
fully and pull them back towards the rear of the
stroller to the desired layback position.
B
Lift the backrest to select a more upright seating
position.
DO NOT ADJUST THE BACKREST WHILE YOUR CHILD IS IN
THE STROLLER.
4. TO USE THE BRAKES
WARNING: Always apply the brakes when parking the stroller. The
stroller may roll away even if left unattended for a few moments.
A
Push down on each brake lever to lock the brakes.
B
Lift each brake lever up to release the brakes.
5. TO SECURE YOUR CHILD IN THE HARNESS
WARNING: Use this harness at all times.
A five-point harness is provided to restrain your child. To
secure the child in the harness, push buckle (A) and (B) into
the buckle housing (C) until the buckle prongs snap into
position. Carefully adjust the harness by pulling the slider (D)
until the desired fit is achieved in the lap, shoulder and crotch
straps. Always adjust the harness when changing the seating
position of the child. To release the buckle, squeeze the top
and bottom prongs.
6. USING THE TETHER STRAP
WARNING: Use the tether strap to prevent the stroller from
rolling away.
NOTE:
A tether strap is fitted to this stroller, place the loop over
desired wrist when using the stroller.
A
Should you need to change wrist, remove the tether strap
and apply to the other handle. To ensure a tight fit, loop
the tether strap around rather than over the handle.
Open the end of the tether strap and insert the opposite
end through the opening created. Pull until tether strap
tightens around handle.
NOTE:
Fit the strap below the frame support bar so that is
does not slide off the handle.
A
B
www.britax.com.au
www.britax.com.au
Holiday Layback Instructions.indd 7-8
19/03/2008 2:16:18 PM
