Britax ONE4LIFE CLICKTIGHT Series, User Manual

Page: 16 / 55

26 27
Table of Contents Table of Contents
11� Ensure both CLICKTIGHT
release buttons are
visible.
NOTE: If it is difficult to
close, you may have locked
your vehicle seat belt or
removed too much slack.
12� Connect the top tether
hook to the vehicle’s top
tether anchor (check the
vehicle owner’s manual
for location).
13� Pull the loose tether
strap end to remove
slack and secure excess
webbing with the elastic
band attached.
Installation with Lower Anchor Connectors and Top Tether (LATCH)
Do not install by this method for a child weighing more than
30 pounds (13.5 kilograms).
1�
Extend
the top tether strap
by lifting on the top tether
adjuster.
2� Unhook the top tether hook
from the back of the child
restraint and place it up and
over the seatback.
3� Open the CLICKTIGHT.
Squeeze the CLICKTIGHT
release buttons underneath
the front cover flap and lift
to open.
4� For models WITH storage
pouch only: Open the
storage pouch.
Remove the lower
connectors by pressing
the spring tab, pushing
the connector back while
rotating down and forward
off the anchor point.
5�
Extend
lower connector
strap to its longest length
by pressing grey button on
adjuster.
6� Recline child restraint to the
appropriate position. Refer
to page 15 to determine
appropriate recline position.
7� Place child restraint
FORWARD -facing on the
vehicle seat so that the
car seat base is flat on the
vehicle seat and is parallel to
vehicle seat.
8�
Ensure
that no more than
3 in. (7.5 cm) of the base
hangs over the front edge
of the vehicle seat.
3 in
9
Both red CLICKTIGHT release buttons are visible after
installation.
9
All connections are secure and vehicle belt is not twisted.
9
Car seat base MUST be flat on vehicle seat and MUST be
parallel to vehicle seat.
9 Recline indicator is still within the correct section for
FORWARD -facing, after child is secured.
9
Child restraint cannot be moved front to back or side to
side more than 1 in. (2.5 cm) at the belt path.
9
Both vehicle lap and shoulder belts are routed through the
CLICKTIGHT.
9
Excess top tether webbing is contained within your vehicle
and secured.
9
The anti-rebound bar MUST be removed.
NOTE: If the child restraint does not meet the above
criteria, repeat the installation steps or use a different
seating location in your vehicle.
With storage
pouch
Without
storage pouch
(Select Models)