Britax ALLEGIANCE, User Manual

Page: 13 / 96

11
EMBLEM/ALLEGIANCE Canadian User Guide
8. Push down into the
middle of the child
seating area with
moderate force while
removing all slack from
the bottom (lap) part of
the vehicle belt and close
the lock-off (see page 24).
IMPORTANT: Both the
vehicle lap and shoulder
belts must be routed
through the lock-off.
9. Push down into the middle
of the child seating area
with moderate force while
pulling the top (shoulder)
part of the belt between
the belt slots to remove
any remaining slack
through the lock-off.
10. Replace the seat cover
and infant positioning
pillow, if required (see
page 24).
Rear-Facing Installation with Lap-Shoulder Belt
9
All connections are secure and straps are not twisted.
9
No more than 7.5 cm (3 in.) of the base hangs over the
edge of the vehicle seat.
9
The anti-rebound bar is properly installed (see page 26).
9
The child seat cannot be moved front to back or side to
side more than 2.5 cm (1 in.) at the belt path. If the child
seat is not secure, repeat installation or use a different
seating location.
9
The child seat is correctly installed when angle guide line
is parallel to the ground when the car is parked on a level
surface. After the child is secured, the recline angle of the
child seat should be 30° – 45° from vertical (not to exceed
45°) when the car is parked on a level surface. See “Seat
Positions” on pages 24 - 25.
9
Tether webbing is stored in storage pouch. See page 30.