6
ENGLISH
For wall mounting (optional), you will need: two screws (e.g. 5 mm
thread diameter) and, if required, two wall plugs suitable for your
type of wall.
Please follow the diagram below (see fi g. 7) and perform the steps
in the right order.
a
) Connect supplied T-piece on your cold water supply
a. Insert one 3/8" gasket into the female nut of the supplied
T-piece.
b. Connect this end of the t-piece to your cold water supply.
!
If you do have an additional free 3/8” cold water supply for
the BRITA 3-Way Water Filter Dispenser in your kitchen, you
do not need to install the supplied T-piece!
If your cold water supply does not fi t the 3/8" connector of
the T-piece, use the supplied adapter if required. Please
insert the 1/2" gasket into the female nut of the adapter fi rst.
Your Starter Kit comes with two 1/2" adapters. Please go to
your nearest supplier for adapters in other sizes.
b
) Connect the hose with the blue stripe to one side of the T-piece.
c
) Take the hose with two 3/8" connectors. Insert the 3/8" gaskets
into the respective female threads of the two hose ends. Con-
nect one end with the free side of the T-Piece.
d
) Now connect the other end to the fi lter head inlet. This is
labelled “IN” (inlet) and marked with an arrow. Make sure that
the gaskets are seated correctly!
e
) Connect the 800 mm hose which is connected with the
dispenser with the outlet of the fi lter head labelled with an out
arrow.
Hose 2:
800 mm
C
3/8"
B
3/8"
Hose 1:
800 mm
A
3/8"
or Adapter
D
(fi g. 7)
Hot water
supply
Cold water
supply
