Installation cont.
Installation cont.
Installation cont.
Installation cont.
1. Fit the tap body to the sink by putting the plinth and washer in position and securing it by
fixing the Reinforcing Plate underneath the sink. Place the tap body on top of the plinth.
2. Using the Fixing Kit, thread the fixing C-rubber washer and C-plate rubber washer onto
the threaded rod, securing in position with the nut. Screw the spray nozzle on to the hose.
3. Feed the hose through the black protective tube, cut-out side towards you. Next, feed the
white protective tube, arrows pointing towards you and attach the tube to the threaded
rod.
4. Feed the hose weight on to the hose and connect it to the threaded rod, with the red
washer sealing it.
5. Fit the flexible tails to the copper tails and attach the check valves to both of the inlets.
Then connect the hot and cold supplies.
6. Fully open the cartridge letting it run for a few minutes and check all joints for leaks.
Flexible Connecting Tails:
Flexible Connecting Tails:
Flexible Connecting Tails:
Flexible Connecting Tails:
Care must be taken when connecting the
flexible connection pipes to the household
pipework to ensure they do not bend sharply
and kink or twist.
See below for recommended ways to fit
the flexible connecting pipes
Important:
Important:
Important:
Important:
Failure to follow these guidelines may result in poor performance and
damage to the flexible connecting pipes
07
