13
6.1
Flexible Inlet and Outlet Hoses
The pump inlet and outlet ports are threaded G ¾ M. These ports are provided
with a flat sealing face suitable for use with an appropriately sized flat faced fitting
and fibre or rubber washer. Ensure a water tight seal is achieved when the pump
is both stationary and running.
Figure 7
a.
Hoses incorporating integral isolating valves should be applied to the inlet
side of pump to satisfy servicing requirements.
b.
Standard hoses with no integral isolating valve should be applied to the
outlet side of pump.
c.
Use correct tool for opening and closing integrated isolating valve to
prevent damage.
Please note
these valves are of quarter turn design, rotate clockwise to
close and anti-clockwise to open. Failure to comply with these instructions
could lead to valve damage.
d.
WARNING: Pump must not run with valve closed.
e.
Flexible hoses with integral isolating valves
do not
replace system isolation
valves which must be installed.
Open
Close
Summary of Contents for ST PUMP 15TN
Page 31: ......
