Bidet mixer with pop
Bidet mixer with pop
Bidet mixer with pop
Bidet mixer with pop----up waste & basin / Tall basin mixer without waste
up waste & basin / Tall basin mixer without waste
up waste & basin / Tall basin mixer without waste
up waste & basin / Tall basin mixer without waste
1.
Identify all components and check for completeness, particularly before commencing installation.
2.
Install mixer (for tall basin mixer add extension tube (14) to mixer body (7) first) to the basin/bidet. Secure the
mixer to the surface of the basin/bidet using the fixing kit, with the washer (8) over the basin/bidet. Fix the
fixing studs (10) then fit the ‘C’ shaped rubber & metal washers (9&11) and secure with the fixing nuts (12).
3.
Screw in connecting flexi tail pipes (13) by HAND ONLY
HAND ONLY
HAND ONLY
HAND ONLY (do not over tighten) and then connect the hot and
cold supplies.
4.
Fit the pop-up waste (if applicable), with the flat washer below and the shaped washer above the bidet. It is
advised that a silicon sealant be applied to both sealing faces of the washers. The plug height can be set by
adjusting the waste rod, operating rod, rod connector and then screw in the base of the plug. Friction for the
waste mechanism can be adjusted using the waste cap (15). (DO NOT OVERTIGHTEN). Please make sure
(DO NOT OVERTIGHTEN). Please make sure
(DO NOT OVERTIGHTEN). Please make sure
(DO NOT OVERTIGHTEN). Please make sure
waste operating rod fits through the hole in the mixer and bidet
waste operating rod fits through the hole in the mixer and bidet
waste operating rod fits through the hole in the mixer and bidet
waste operating rod fits through the hole in the mixer and bidet to connect pop
to connect pop
to connect pop
to connect pop----up waste before final
up waste before final
up waste before final
up waste before final
fixing
fixing
fixing
fixing.
5.
Turn on the water supplies. Lift and turn handle both ways for a few minutes, letting the water flow, to check
all joints and connections for leaks.
BIDET MIXER
BIDET MIXER
BIDET MIXER
BIDET MIXER
BASIN / TALL BASIN MIXER
BASIN / TALL BASIN MIXER
BASIN / TALL BASIN MIXER
BASIN / TALL BASIN MIXER
1. Cap x1 9. Rubber ‘C’ Washer x1
2. Grub Screw x1 10. Fixing Studs
x2
3. Handle x1 11. Metal ‘C’ Washer x1
4. Shroud x1 12. Fixing Nuts
x2
5. Locking Nut x1 13. Flexi Tails
x2
6. Cartridge x1 14. Waste Assembly x1
7. Body x1 15. Friction Adjustment Screw x1
8. Washer x1
1. Cap
x1 9. Mixer Extension (TBAS C) x1
2. Grub Screw x1 10. Washer
x1
3. Handle x1 11. Fixing Studs
x2
4. Shroud x1 12. Rubber ‘C’ Washer x1
5. Locking Nut x1 13. Metal ‘C’ Washer x1
6. Cartridge x1 14. Fixing Nuts
x2
7. Body x1 15. Flexi Tails
x2
8. Flow Straightener x1
14
10
7
4
13
9
6
3
12
8
11
5
2
1
15
NOTE:Please note
that the Bidet M ixer
is fitted with
a directional nozzle.