Installation cont
Installation cont
Installation cont
Installation cont
....
Bath Shower Mixer
Bath Shower Mixer
Bath Shower Mixer
Bath Shower Mixer
1. Identify all components are present prior to starting installation using the diagram
overleaf.
2. Slide the base washer (15) onto the threaded tails of the tap body and install the mixer
body (6) to the bath.
3. Using washers (8) and the backnuts (9) secure the mixer body (6) to the bath by
tightening the backnuts (9) onto the threaded tails. A suitable spanner (not supplied)
may be required to fully tighten the backnuts (9).
4. Connect the hot and cold water supplies using ¾" tap connectors (not supplied).
5. Fit the shower hose (10) to the hose outlet using the small washer, and the handset (11)
to the hose using the small washer.
6. Fit the wall bracket (12) to the wall using the fixings supplied, ensuring the handset (11)
and hose (10) reaches it comfortably.
7. Turn the handles in both directions, letting the water flow for a few minutes to check all
joints and connections for leaks.
joints and connections for leaks.
8. To switch from bath to shower mode, simply pull the diverter up. After use the mixer
automatically reverts to the bath filling mode.
NOTE
NOTE
NOTE
NOTE: The mixer incorporates a ‘lock-up’ diverter feature, for use with low pressure
water systems. Simply twist the diverter knob when in the up position to lock in the
shower mode. After use twist back to allow diverter knob to drop back down to bath
filler mode
1.
Handle
x2
9.
Backnut
x2
2.
Indice
x2
10.
Shower Hose
x1
3.
Grub Screw
x2
11.
Handset
x1
4.
Spline Adapter
x2
12.
Wall Bracket
x1
5.
Valve
x2
13.
Diverter Assembly
x1
6.
Mixer Body
x2
14.
Hose Outlet
x1
7.
Anti-Splash Assembly
x2
15.
Base Washer
x1
8.
Washer
x2
10