Cleaning & Maintenance
Cleaning & Maintenance
Cleaning & Maintenance
Cleaning & Maintenance
Your fitting has a high quality finish and should be treated with care to preserve the visible surfaces. All finishes
will wear if not cleaned correctly. The only safe way to clean your product is to wipe with a soft damp cloth.
Stains can be removed using washing up liquid. All bathroom cleaning product (powders and liquids) will
damage the surface of your fitting, even the non-scratch cleaners.
NOTE:- Never use abrasive detergents or disinfectants or those containing alcohol, hydrochloric or phosphoric
acid.
Traditional type valves: - If the fitting leaks from the spindle
1.
Remove fitting head (if necessary).
2.
Tighten gland nut on top of valve.
All valve types: - If the fitting begins to drip
1.
Turn off the water supplies.
2.
Remove fitting head and valve.
3.
Carefully clean seating and rubber washer.
4.
Replace valve and turn on the water supplies.
5.
If the problem persists contact our customer service helpline.
IRN R001
IRN R001
IRN R001
IRN R001
See text of entry for Installation Requirements or Notes.
Bristan recommend E-Cloth for cleaning all of our bathroom & kitchen products.
Using just water, E-cloth gives a smear free, deep clean by breaking up and
holding dirt, which normal cloths leave behind. Order through your Bristan
stockist.
(ORDER CODE: ECLOTH)
IMPORTANT
IMPORTANT
IMPORTANT
IMPORTANT ---- PLEASE READ
PLEASE READ
PLEASE READ
PLEASE READ
This fitting needs to be installed in accordance with the follow
This fitting needs to be installed in accordance with the follow
This fitting needs to be installed in accordance with the follow
This fitting needs to be installed in accordance with the following Installation Requirements and Notes
ing Installation Requirements and Notes
ing Installation Requirements and Notes
ing Installation Requirements and Notes
(IRN) to ensure they meet the requirements of the Water Supply (
(IRN) to ensure they meet the requirements of the Water Supply (
(IRN) to ensure they meet the requirements of the Water Supply (
(IRN) to ensure they meet the requirements of the Water Supply (Water Fittings) Regulations 1999 and the
Water Fittings) Regulations 1999 and the
Water Fittings) Regulations 1999 and the
Water Fittings) Regulations 1999 and the
Scottish Byelaws 2004.
Scottish Byelaws 2004.
Scottish Byelaws 2004.
Scottish Byelaws 2004.
IRN R006
IRN R006
IRN R006
IRN R006
This tap or combination tap assembly has a Type AUK3 air gap and is therefore for installation in any premises to
protect against a backflow risk up to a Fluid Category 5.
