© BriskHeat
®
Corporation. All rights reserved.
5
ACR
®
3 Hot Bonder
GETTING TO KNOW YOUR ACR
®
3 HOT BONDER
Full-Color Touchscreen Interface
ype J Thermocouple
Main Power Switch and Circuit
Breaker Switches
Inputs Vacuum Hose Inputs, Vacuum
Adjustments, and Vacuum Pump
Switch.
Power Input Receptacles
Printer and Printer Feed Button
Heater Output Receptacles
USB Data Port
© BriskHeat
®
Corporation. All rights reserved.
6
ACR
®
3 Hot Bonder
SPECIFICATIONS
General
Single or dual zone
8.4” (213mm) touch screen with easy-to-use interface
USB port for data transfer
Input ground fault interrupter breaker protected
Audible and visual alarms for high and low temperature / vacuum limits
Power
Input Voltage: 100-130VAC, 200-240VAC
MAINS supply voltage fluctuations up to ±10% of the nominal voltage
Transient overvoltages typically found on a Category II power source: i.e. a lighting circuit
Frequency: 50/60Hz
30 amps maximum per zone
Maximum output rating: 240VAC, Single Phase
Environment
Intended for use in dry environments. Do not expose to spray
Altitude up to 6562ft (2000m)
Storage temperature range: -4°F to 140°F (-20°C to 60°C)
Operating temperature range: 41°F to 104°F (5°C to 40°C)
Maximum relative humidity: 80% for temperatures up to 88°F (31°C) decreasing linearly to
50% relative humidity at 104°F (40°C)
Pollution Degree 2 (Normally only non-conductive pollution occurs, however a temporary
conductivity caused by condensation must be expected)
Vacuum
Pressure: 27-28in Hg (13.26-13.75PSI)
Flow: 5.7 scfm (Vacuum Venturi)
0.9 scfm (Electric Vacuum Pump)
Ability to manually adjust pressure for each zone
Temperature Control
Cures up to 1400°F (760°C)
10 thermocouple sensor inputs per zone
Accepts mini Type J thermocouple connectors
