================================================================================================
1009725-E
12
ASSEMBLY
Using the hardware in
PANEL 10
,
assemble one 3/8” Nut (17) on each end
of the Hamper Stop Rod (67) until it is
approximately in the center of the threads.
Assemble each end of the Hamper Stop
Rod (67) through the holes on the front of
the Upper Side Tubes (38) and Lower Side
Tubes (69).
STEP 10
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
STEP 11
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
STEP 12
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Using the remaining hardware in
PANEL 10
, assemble one
3/8” Lock Nut (22) on each end of Hamper Stop Rod (67).
Tighten the Lock Nut (22) until Hamper Stop Rod (67) is flush
with the top of the Lock Nut (22).
Note: Hold the Hamper Stop Rod (67) with
Pliers while tightening the Lock Nuts (22).
Upper and Lower Side Tubes should be trapped between the
Nut (17) and Lock Nut (22) on the Hamper Stop Rod (67) but
still loose enough to pivot freely. If the tubes do not pivot freely,
loosen Nut (17).
67
17
67
17
38
22
69
38
40
40
22
69
17
Hook
Snap
Snap
“J” Channel
Pull up on bottom of Hamper (40) from “J” Channel and hook
“J” Channel onto Hamper Stop Rod (67).
Take side flaps of the Hamper (40) around the frame and snap
to the bottom of the Hamper as shown.
Note: Flap should be on the outside of the
Lower Side Tubes (69) after assembly.
67
17
38
22
69
38
40
40
22
69
17
Hook
Snap
Snap
“J” Channel
67
17
38
22
69
38
40
40
22
69
17
Hook
Snap
Snap
“J” Channel
“J” Channel
